AQUA SAVER BY PJB CO
5773 PLEASANT VALLEY ROAD
COGAN STATION PA 17728
PHONE 570-435-5412 or 570-692-1875 to those on AT&T call is free E-MAIL aquasaverbypjbco@chilitech.net
We now offer payment via Paypal. We do accept personal checks, bank checks, and money orders. When sending us the info please includeyour full name, address, phone number or email, and a time that will be good for us to get in touch with you.
We will hold the product until the personal check clears. Bank or money orders will ship out upon receiving the order.
RV,
CAMPER, BOAT OWNERS STOP! LOOK! READ!
Which tank would you want to drink from?
This photo
above center was sent to our company unsolicited from a member of FMCA, Who
ordered the patented aqua saver through the April Issue magazine 2004 he states that
he had already removed about three gallons of sludgefrom
his 1996 Monaco dynasty when this photo was taken.
There
are two fresh water tanks shown above, the one on the left the owner cleaned
and flushed before a RV rally (not a tank with an Aqua Saver); the one on the
right is a tank with an Aqua Saver installed (1996) and has had nothing but
well water filtered through just a paper filter. Twice chlorinated water was
used at a campsite when the owners ran low and needed water. Hated that
chemical taste
QUESTION Washing your car! You pre wet the car you apply soap you wipe
the suds around you rinse off you get in and there is a nice streak on the
hood you missed NOW if you cant remove the streak after all that and is in the
open how can you flush out a tank when you cant get inside.
FLUSHING AND FLUSHING YOU JUST CANT TRUST ANDYOU WASTED A LARGE AMOUNT
OF WATER AND TIME
Hot water tank
smell,!! More than likely it started from the fresh water tank. You
did not get your fresh water tank clean when flushing. Or dry for storage
Is your
fresh water tank clean after all the flushing and sanitizing? our satisfied
customers knows the difference!! They are saving time, money, And where water
is precious. water!! Flushing a tank depending on
tank size can take anywhere from 60 gallon on a 30 gallon tank up to 200
gallon on a 100 gallon tank if not more.
Cut in If tank is bowed down and the flange is not going to be flat where you want the flange to set place in hole with large rubber gasket. Place clamp on each side where the flange is away from the tank draw the tank to the flange now you can drill all the hole remove clean debris.
installation, our way Open tank for aqua saver. Mark tank where you wish to place the aqua saver, you'll need a 10” X 10” flat open surface, If there is a spin weld plug on tank and it is in your way, You can move your flange to where you can cut it out with the hole saw or wood rasp it to smooth it out. Cut in hole, letting the saw do the work.
Place gasket on flange then place in new hole, Next with a ¼” sharp bit.
Drill and pin then drill a crossed from the first pin using the backer block.
Drill the other hole. Do not move drill bit in and out as you will in large the hole. Remove all debris with a wet dry vacuum, A clean tank is safe water tank, water will last longer and not turn raunchy in a short time, Could be a life line in time of emergency.
Cleaning tank for the first time
Remove all debris from tank wet/ dry vacuum, Use a drinking water hose with filter DO NOT use a garden hose. Making sure the tank is damp all over just lightly dampen tank if not, Dump or spray tank with Clorox it easy with a small sprayer, if not dump in the bottom of tank. brushing tank. using a sprayer you just lightly brush the tank top, sides bottom, and ends rinse down vacuum, rinse down vacuum, and rinse and vacuum for the final time
Job should be done check for any missed spots and touch up
No sprayer dump Clorox in bottom of tank dip in Clorox brush tank use little more Clorox for this operation.
Tools for cleaning for long tanks and end opening, 100 to 250 gallon tank. We use a painter pole for extension with a brush on the end. a small brush for around the opening and side where you cant get the brush and the painter pole small tanks may or can be done with one brush.
Installation tools 3/8 electric drill, ¼” sharp drill bit, 7/16 open end wrench or a 7/16 nut drive and our hole saw makes a perfect hole no guess work
Bulk head kit can be placed in tank for faster draining $29.50
This is where I put my AQUA SAVER, it is on the top of our
tank:
Here are some pictures showing where other people installed
their AQUA SAVER:
SIPHON KIT instructions is in the box with aqua saver placing this in line will allow you to winterize your unit leaving tank dry and free of antifreeze
Trip and storage between trips or storage open drains vacuumed outTank stays cleaner.
Hole Saw Sale $30.00, return it in good working order, and we will send you a check for $26. It makes the job quicker, no guess work, let the saw do the work it makes a perfect opening.
Aqua saver - List $144.00 - Sale $88.00 s/H included
No high speed machinery used in making this unit all done by hand.
Guarantee it is guarantee for as long as you own the unit it was put on not transferable
100 gal We have cleaned a 100 gal. bounder tank in about 15 min. with about five gallon of water and Clorox.
Made in the USA Over the past 15 years we can not tell you how many of the so called do not leaking deck plates we have replaced. With our aqua saver. Because of the leak’s we bought one it came with no wrench to tighten down the screw in cap plate the o ring is not protected from ware and there was no fastener and no seal between the plate and tank. And it stated do not place where internal pressure is against plate it does not use food grade rubber seal, or medical grade plastic or to cut in a perfect hole as the hole saw that we offer does.
In short you get what you pay for. It is American made you cant compare the deck plate with our product you can place our unit top, side, or end where ever you have a flat 10” X 10” open surface.
Now why is there no RV camper dealers handling our unit because it takes away chemical sales less filters sales less service in short less profit. would any rec. dealer be honest or any manufacture admit to an unhealthy tank
HELL NO We have been hearing it all. It's over priced, It will cross thread, it’s a piece of junk, It Leaks, not any of it is true.
Generator exhaust ext list $247.00 sale $213.00 + shipping $18.00 anywhere usa 6% tax pa. This unit does not attach to coach other than to the 1 and ½” exhaust pipe all adjustments are at the base of system
PJB Co. 5773 Pleasant Valley Road Cogan Station, PA 17728 570-435-5412 (phone) or 570-692-1875 to those on AT&T call is free
9:00 AM To 4:00 pm Monday to Friday
E.S.T.
Order via Paypal
Aqua Saver
List $144.00 - Sale $88.00 - S/H included
Hole Saw
$30.00 - Return saw in good order get back $26.00
$4.00 is for helping to ship the saw to you
Generator Exhaust
List $247.00 - Sale $213 + S/H $18.00 any where in usa.
We do accept personal checks, bank checks, and money orders. When sending us the info please include your full name, address, phone number or email, and a time that will be good for us to get in touch with you.
We will hold the product until the personal check clears. Bank or money orders will ship out upon receiving the order.
Other Links on the Internet where you can find us: